1.
Start
by unpacking the cover and
placing it over the pool,
black side up, such that the
blanket is laying on the
pools water and its edges
are overlapping on to the
pool surround / deck.
2.
Feel through the
cover to the edge of the
pool and mark the outline of
the pool with chalk or a
pencil onto the blanket
allowing for any overhang
due to the pools coping /
edging.
If using a pool reel, allow
for any extra needed as per
the pool reel
instructions.
3.
Next, lay the cover out on a
flat surface and trim the
cover to the lines that you
have marked. Discard
the off cuts and allow the blanket to rest on the water
surface. There may be some
fine trimming needed, to
make the blanket fit precisely
to the pool sides.
4.
IMPORTANT: If your pool is
fitted with water jets that
return filtered water at
surface level then these
need to be either aimed
downwards or switched off.
Because the Revolution Pool
Cover isn't full of air
pockets, surface level jets
can, in extreme
circumstances, swamp or
flood the cover and / or
push it towards the middle
of the pool.
The 'Revolution Pool
Cover' is compatible with
all known reel solutions.
If using a reel to stow the
blanket when not in use,
attach towing kits / reel
straps as per the
manufacturers instructions
provided with such
kits.
Finally,
allow the 'Revolution Pool
Cover' to float on the water
surface and let it start
adding heat to your pool.
